Whatcanbe hard is figuring out how to remove the old towelbar, especially when there are no visible screws.
In this case, it may be worth it to stick with what you have.
It might just require you to look a little closer.
The Spruce / Sanja Kostic
Once found, determine what tool you’ll need to loosen the screw.
This will likely be a small Allen wrench or mini screwdriver.
Loosen Set Screw
Using the required tool, loosen the set screw.
The Spruce / Sanja Kostic
If there is a set screw on each side, loosen each set screw.
It may also be helpful to pull outward from the wall as you do so.
Unscrew the screws and remove the bracket, then use needle-nose pliers to remove thedrywall anchors.
The Spruce / Sanja Kostic
Then simply pry the anchor out of the wall using the screw head.
In this case, the end posts are likely attached to the bracket via a locking tab system.
Locate Locking Tab
Search along the base of the end posts to find the locking tab.
The Spruce / Sanja Kostic
It will most likely be positioned at the bottom or the side of the posts.
Depress Tab
Use a small screwdriver to depress the tab.
Remove End Post
Remove the end post by manipulating its position while depressing the locking tab.
The Spruce / Sanja Kostic
First, try pulling away from the location of the tab.
Repeat on the second post.
Unscrew and remove the brackets from the wall, as well as the drywall anchors.
The Spruce / Sanja Kostic
This is especially common for towel bars mounted to tile and similar surfaces.
This is most easily done using an oscillating multitool.
Position the blade between the post base and the wall, and cut the adhesive or mortar away.
The Spruce / Sanja Kostic
Repeat on the second post.
Warning
Cutting mortars and adhesive with an oscillating multitool can create harmful dust.
Always wear a proper dust mask when doing so.
The Spruce / Sanja Kostic
Clean Off Remaining Material
Clean the excess adhesive from the wall using a scraper or sander.
Start by using a utility knife to cut any fraying paper from around the hole.
Try not to make the hole larger in the process, as this will require a more complex patch.
The Spruce / Sanja Kostic
Fill Hole and Paint
Fill the holewith joint compound and allow it to dry.
Once dry, sand, smooth, and paint.
The Spruce / Sanja Kostic
The Spruce / Sanja Kostic
The Spruce / Sanja Kostic
The Spruce / Sanja Kostic
The Spruce / Sanja Kostic
The Spruce / Sanja Kostic
