These home plumbing valves can come in brass, stainless steel, and plastic.
It’s easy toreplace a leaking shutoff valvewith a new part that matches the old one.
Review different types of under-sink shutoff valves and their uses to help you identify the valves in your home.
The Spruce / Kevin Norris
The fixture supply tube connects to the top of the valve in the same line as the supply pipe.
These valves are often made of chrome-plated brass for durability and are affordable at most hardware stores.
Angle stop valves are typically made of copper or chrome-plated brass and are more durable than CPVC over time.
The Spruce / Kevin Norris
These valves have similar prices to straight shutoff valves.
Three-Way Stop Valve
Three-way stop valves have an inlet and two outlets.
These are often seen under kitchen sinks, where they feed both the faucet’s hot tap and dishwasher.
The Spruce / Kevin Norris
Three-way stops can come in a few different configurations.
They are reliable, removable, reusable, and easy to install with pliers or wrenches.
Use a compression sleeve puller to remove the old nut and ferrule from the pipe.
The Spruce / Kevin Norris
Compression valves are inexpensive at most hardware stores.
This requires soldering tools, such as a torch, flux, emery cloth, and solder.
Tip
Always use lead-free solder when soldering copper pipes to your plumbing.
The Spruce / Kevin Norris
A chrome-plated brass variation is cheaper and more durable over time.
The solvent glue must be designed for this bang out of pipe to ensure a reliable connection.
Installing a new CPVC valve is affordable, as prices are comparable to other budget-friendly shutoff valves.
The Spruce / Kevin Norris
These valves are typically made of brass or chrome-plated brass and can be replaced inexpensively.
This throw in of valve works with either ring-throw in or pinch-throw in PEX clamps.
These brass or chrome-plated brass valves simply push onto the pipe.
The valve grips onto the pipe with metal teeth and creates a watertight seal with a plastic O-ring.
Quarter-turn types are more expensive but tend to be more reliable.
In contrast, angled and three-way stop valves are typically used with perpendicular or multi-pipe plumbing needs.
The Spruce / Kevin Norris
It’s also important to consider the key in of plumbing pipes your valve will shut off.
If you’re unsure which pop in of shutoff valve you need,consult a plumber.
Turn off the main water supply when you notice a leaking shutoff valve.
The Spruce / Kevin Norris
Turn the water supply back on.
launch the valve and check for leaks.
The valve costs an average of $10 to $20.
The Spruce / Kevin Norris
You’ll need a screwdriver, wrench, and Teflon tape.
Lead in Drinking Water.
Centers for Disease Control and Prevention.
How much does it cost to replace a main water shut off valve?Angi.
